Semi Step 2 ****Take your RJ45 connection which without resistor and battery clip.And take the whole cover from on it.
#DIY LIGHTED ETHERNET STATUS TESTER PATCH#
Semi Step 1 ***When you finished to placing the LEDs what you want to do is stretching the negative (-) legs of the LEDs to each other but in order.Like in the pictures just patch them to lower another LED.And After you finished you must have only 1 enterance for negative legs.Solder all of em together. REMINDER : You will need the same thing 2 times so to other connector you may continue the ways again. * Go ahead and take the cover of the RJ45 Female connector * As you can see there is colors which indicates the proper location of the cables * Omg same colors with cables which we cut before :) * Now locate them in proper location you may want to use screwdriver to keep them harder because they always try to go off * In that part you will punch some cable This part is the most important and the may be only risky part of our project.The biggest fault in the punch down tool usage is cutter site.Punch down tools mouth has 2 sides 1 of them should be Cutter im sure your tool will indicate clearly too.What we are going to do is we will locate our punch down upon the cable but be sure ****CUTTER SIDE MUST LOOK OUTSIDE**** in order not to cut connection between cable and connector.When you all done be sure there is no cable/s hanging sideways of the connector.If there is some cut them manually *We are done with first connector.
* Now you will see the cables will be together you need to seperate them * You do not need to cut the heads of the cables punch down tool will do that job for us. * When you cut the Cable from the middle take one of em and cut the covers like 2-3 cm from each side. Ok here we go * First step is cutting the UTP cable from middle.Like 10 cm is going to be Ok.